Letter to the editor: North America Traffic president
April 3, 2018 - To the construction industry and motorists everywhere, all of us here at North America Traffic were deeply saddened on that awful day in July 2014, when Brian Daniel lost his life, doing his job.
Now, the Coroner’s Jury report, just released this past month (February 2018) by Dr. Elizabeth Urbantke, takes us back to the tragic events at the construction site on Highway 3, near St. Thomas, Ontario, and reminds us of why we are here. Brian was a flagger on duty at the site, working to keep the traffic flowing safely, when he was struck and killed by a passing vehicle.
And we are reminded, accidents like this simply should not happen.
The Jury’s report makes several recommendations for making road workers safer. We fully endorse all of them. To be transparent, as a manufacturer of the type of automated devices recommended by Dr. Urbantke’s panel, North America Traffic stands to benefit from regulatory changes such as these.
But our values runs deeper than that.
The death of Brian Daniel struck home for us, because it happened in our own backyard. Driving east from that point on Highway 3 in Southwestern Ontario, will bring you virtually to our front door. The founder of our company, Peter Vieveen, knew that road well. Over twenty-two years ago, Peter already feared for the safety of road construction flaggers. As a construction supervisor, he had seen more than enough near-misses to recognize the inherent dangers faced by those who stand at the roadside on a busy jobsite and attempt to direct the constant stream of cars and trucks and buses.
Peter was fearful enough to go home to his garage and go to work on a safer solution. There, he invented the original Automated Flagger Assistance Device, or AFAD, which is the cornerstone of our business today.
Since then, the industry has produced numerous signalling systems that can allow road builders to control traffic in work zones without putting their crews in harm’s way. AFADs and other systems are, in fact, already in widespread use throughout Canada and the United States – widespread, but not yet the norm.
As Dr. Urbantke’s report rightly notes, different roadways fall under different jurisdictions and safety guidelines, even within a single county. Portable devices with remote controls, like the AFAD, have now been in service since 2001. For some reason, though, the regulatory bodies responsible for highway and jobsite safety have been slow to encourage or mandate their use.
Two of the new Coroner’s recommendations address this problem:
• Require the use of AFADs, or appropriate devices for regulation/control of flow of traffic, provided there is no danger to workers or drivers caused by road conditions, on all highway construction sites… where workers are within 3 meters of a travelled lane open to traffic
• Require the active discussion, post-acceptance of tender and prior to job commencement, between the Constructor and the (Ministry of Transportation) aimed at addressing the use of alternatives to traffic control persons, such as AFADs or appropriate devices
Brian Daniel lost his life trying to keep others safe. If these Coroner’s recommendations finally lead to positive action for safer guidelines in Ontario and across the continent, perhaps his good work, as well as Peter’s and others, will continue and in future, lives will be saved.
Jordan Sherlock, president
North America Traffic Inc.
No more low-bid wins: Alberta announces new bidding evaluation processThe Government of Alberta has announced that a new bidding…
AEM launches "Mission Not Accomplished" campaignThe Association of Equipment Manufacturers (AEM) kicked off a new…
Public-information roadblocks must goAs any driver can attest, Manitoba needs to invest billions…
Canadian rental revenues forecast to reach $5.4BAccording to the latest rental revenue forecasts from the American…
NAPA 2018 IMPACT Leadership Conference
September 12-14, 2018
BCRB Fall Conference
September 16-18, 2018
NAPA International Conference on Stone Matrix Asphalt
November 5-7, 2018
CTAA Annual Convention
November 11-14, 2018
SHCA Annual Fall Convention
November 15-16, 2018
CCA Fall Board Meeting